Tianjin Jinfan Mould Co., Ltd.
-
Sobre nosotros
-
-
Producto
-
-
-
-
GOLDENSAIL
06
2023
-
01
Fixing form of plate gasket of plate heat exchanger
Autor:
Under normal circumstances, the fixing forms of the sealing gasket are divided into three types: paste type, inlay type and buckle type. The sealing gasket must be completely consistent with the sealing groove of the plate heat exchanger to achieve the sealing effect.
(1) Sticking type: After applying sealant on the gasket groove, stick it directly in the installation groove of the heat exchange plate.
(2) Embedded type: The heat exchanger plate is designed with assembly holes, and rubber nails are designed on the side of the sealing gasket. After the sealing gasket is placed in the sealing groove, the rubber nails are embedded in the assembly holes.
(3) Snap-on type: There is a mountain-shaped buckle on the side of the sealing gasket, and the sealing gasket is buckled on the heat exchange plate with the buckle.
Gasket replacement
(1) Remove the used gasket. Be careful not to scratch the inside of the gasket groove when disassembling.
(2) Use acetone, methyl ethyl ketone or other ketone solvents to remove the residual glue in the gasket groove.
(3) Clean the gasket groove and gasket with a clean cloth or cotton yarn.
(4) Apply the adhesive evenly in the gasket groove.
(5) Install clean new gaskets on the board.
(6) The plate with the gasket installed should be placed in a flat, cool and ventilated place to dry naturally before installation and use.
Página anterior
Página siguiente
Página anterior
Página siguiente
Línea directa:
Correo electrónico empresarial:
Mensaje del cliente
Dirección: No. 8 Jianshe Road, baltai Industrial Park, Jinnan District, Tianjin
Tel: 86-13820961193
Buzón: aadmin@jinfanmoju.cn
Público de WeChat