Tianjin Jinfan Mould Co., Ltd.
-
Sobre nosotros
-
-
Producto
-
-
-
-
GOLDENSAIL
02
2022
-
06
Cases where vicarb heat exchangers cannot be used
Autor:
1. It is not suitable to use vicarb heat exchanger in the range of 250℃. The design temperature of the heat exchanger mainly depends on the temperature that its sealing gasket can withstand. When using rubber elastic gaskets, the maximum operating temperature is less than 200°C; if the gasket is made of compressed asbestos wool, the maximum operating temperature can reach 250~260°C.
2. It is not suitable for heat exchange of fluids that are easy to block the flow channel. Because the distance between the plates of the heat exchanger is very small, most of which are 3 to 5 mm, if there are relatively large solid particles or fibrous impurities in the heat transfer fluid, it is easy to block the flow channels between the plates.
3. The standard pressure below 2.5MPa is not suitable for vicarb heat exchanger. The heat exchanger is sealed by a gasket, the perimeter of the seal is very long, and the support of the two seals of the corner hole is poor, and the gasket cannot meet the pressing force, so the highest task of the plate heat exchanger was at that time. The pressure is only 2.5MPa; when the area of the veneer is more than 1m2, the standard pressure is often lower than 2.5MPa.
Página siguiente
Página siguiente
Línea directa:
Correo electrónico empresarial:
Mensaje del cliente
Dirección: No. 8 Jianshe Road, baltai Industrial Park, Jinnan District, Tianjin
Tel: 86-13820961193
Buzón: aadmin@jinfanmoju.cn
Público de WeChat